1/32 "T" Off-Hub (Original) PropBlurs Phosphor Bronze Spring For Expert Users
- Off-Hub Style 1/32nd scale PropBlur in Phosphor Bronze Spring temper
- There are two different versions of 1/32nd scale PropBlurs:
- This version "T" is meant to illustrate a lower rpm turning prop compared with the other version ("T2"), so we call this "Low Speed"
- Each PropBlur unit here replaces one propeller BLADE
- each Kit (illustrated here) contains 2 PropBlur units (propeller blades)
- 1/32nd PropBlur propellers are very delicate - recommended for experienced modelers
example: If your model comes with a 3-Blade Propeller (like a 1/32nd Corsair) - purchase 2 Kits; use 3 PropBlur Units, leaving one PropBlur propeller blade unused
WARNINGS: 1/32nd PropBlurs are NOT FOR CHILDREN
SHARP POINTS! DANGEROUS! EXPERIENCED MODELERS ONLY.
KEEP OUT OF THE REACH OF CHILDREN AND PETS!
Technical Data:
- Each PropBlur propeller blade is 2.1" long, including the 0.18" end 'stub',
- That represents 67.5" inches, or 5.625' feet at scale
- When installed, it would represent one blade of an ~11' dia. propeller
Caution: 1/32nd PropBlurs are for EXPERT USERS. The 1/32nd scale PropBlurs are very, very delicate by design. The entire propeller blade MUST be kept totally flat when cutting the attachment to the frame and kept totally flat during handling. Any kink, bend, flexing or rough handling may cause the propeller blade to bend or break. The design is made to give the ultimate 'blur' effect by representing the the thinnest possible lines of metal. They are very, very hard to make, and they are difficult to use so I urge caution